StewMac Japanese Fret Slotting Saw with Depth Stop

Fret slots don't need to follow the radius of the fingerboard As long as they are the correct depth on the ends of the frets, having the middle deeper dosen't

StewMac Japanese Fret Slotting Saw with Depth Stop My preference is to initially slot shallow and then using a depth stop on my pull saw, set to the fret tang depth, clean up each slot so that

Fret slots don't need to follow the radius of the fingerboard As long as they are the correct depth on the ends of the frets, having the middle deeper dosen't

m8win slot If you think it's necessary to radius your fret slots so they'll match the radius of your fretboard

Simply hold the flat edge against the fret tang, note the height of the tang against the reference lines, fit the appropriate curved edge into the slot, and

fret slot saw Be sure your fretwire will fit! Don't wait until after you've installed a fret to discover the slot wasn't quite deep enough! Not sure if your fret slots

037 inches The tang height itself, which translates to the fret slot depth, is not listed But if you do the math subtracting the crown height