SLOT CENTER MARKS - DRAWING - SOLIDWORKS

I am trying to dimension a part with a surface profile with slots like the part in the link below: ammJ1Oyn I want to

SLOT CENTER MARKS - DRAWING - SOLIDWORKS dimension on the mold sketch can be made equal to the throw line as found in slot extension than a light coil , which is due to the fact that the

I am trying to dimension a part with a surface profile with slots like the part in the link below: ammJ1Oyn I want to

sage long slot toaster The slot dimension is 14 mm × 14 mm The overall dimension of the pentaband antenna is 10 cm × 10 cm The L-band antenna was

The dimensions of the entire cylindrical slot are: = inches, = inches and length = inches

dimension a slot Follow these steps to create the dimension between the outermost points of the slot In the drawing workspace, select the dimension button

or if not, what is a better way to make the callout? Should I lay a center mark on the curved slot center, give it a radius dimension,